Unisteer 8001050-02 Ford Faicon/Comet 1960-65 - Manual (Page 6)

pg. 6
655600
4. Install column tube and hardware (leave loose). Note: Do Not Install Shaft Yet. From under
car, install column clamp over tabs on column plate and leave loose.
5. From under car it will be necessary to loosen motor mount nuts. Loosen and remove the four
nuts and bolts that hold motor mount to frame. Note: Remove one bolt at a time and replace
with longer 3/8 bolts supplied in kit. Note: It may be necessary to jack up on engine a little to
relieve pressure off bolt for removal and installation. Install the bolts so that bolt heads face
front bumper.
6. When you have replaced all four bolts with longer set, install four one-inch standoffs over
bolts.
7. Install rack and pinion bracket assembly over four bolts and install flat washers and lock nuts.