Unisteer 8001520 Corvette Manual Rack & Pinion Kit 1963-82 - Manual (Page 5)

Page 5 657080
Final Steps
7. Vehicle will need to be aligned properly after install. Align vehicle as close as you can and torque
down tie rod jam nuts. Take vehicle to professional alignment shop.
Note: To adjust toe on vehicle loosen jam nut and turn inner end. The inner end will turn on the inside
and thread in and out on the outside. Disassembly of the outer ends is not necessary.
If you have any questions or problems regarding this product please contact:
UNISTEER®
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Created on 04/26/2013
Last Revised 6/27/2014
Copyright © 2013 by Unisteer Performance Products. All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Unisteer Performance Products.