Unisteer, Performance products – Unisteer 8051380 GM A-Body Steering Shaft 1964-67 User Manual
Page 3
pg. 3
Note: It may be necessary to slide out diver side bolts & lower rack assembly to enable clearance of u-
joint to shaft.
9. Tighten passenger side bolts and driver side bolts to 40 lbs.
10. Check clearance between header tube & u-joints of shafts.
Note: It may be necessary to adjust heim joint in or out of bracket (up or down) to clear. To do so,
perform steps 2-4 again until adjustment is made.
11. Also, make sure you phase your u-joints. The lower u-joints at the pinion & at the heim must work
opposite of each other. Set them up so that they are 90 degrees apart as they turn.
12. If you rotate your steering wheel and it bumps or binds your phasing is wrong. Continue to adjust by
rotating u-joints.
13. After installation make sure mounting bracket bolts to frame are torqued to 40 lbs.
14. Make sure u-joint bolts are installed & torqued to 25lbs.
15. Tighten jam nuts on u-joints & heim joint.
If you have any questions or problems regarding this product please contact:
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
(9/16/2014)
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Maval Manufacturing Corporation.