UVP GelMax Imager User Manual
Gelmax, Imager, Installation and user instructions
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Web Site: www.uvp.com
- Table of Contents
- Introduction
- System Components
- Setup Instructions
- Components
- Connecting the Power and USB Cables
- Plug the square end of the USB cable into the back of the GelMax. Plug the other end into an available USB port on the user’s computer.
- Plug the main power cable into the back of the GelMax and the other end into a surge-protected power outlet. Set the power switch on the back of the system to the ON (I) position.
- Installing Emission Filters
- Installing the Doc-ItLS Acquisition and Analysis Software
- Using the System
- Service Procedures