Vortex Optics CROSSFIRE II 3-12X56 AO HOG HUNTER RIFLESCOPE User Manual
Page 3
5
4
RIFLESCOPE
II
r
iflesCope
A
djusTMenTs
Reticle Focus
The Vortex Crossfire II Hog
Hunter uses a fast focus
eyepiece designed to quickly
and easily adjust the focus on
the riflescope’s reticle.
To adjust the reticle focus:
1. Look through the
riflescope at a blank white
wall or up at the sky.
2. Turn the eyepiece focus knob in or out until the reticle image is as
crisp as possible.
Note: Try to make this particular adjustment quickly, as the eye will try to
compensate for an out-of-focus reticle.
3. Once this adjustment is complete, it will not be necessary to re-focus
every time you use the riflescope. However, because your eyesight may
change over time, you should re-check this adjustment periodically.
Variable Power Adjustments
To change magnifications, turn the magnification ring to the desired level.
Warning
Looking directly at the sun through a riflescope, or any optical instrument,
can cause severe and permanent damage to your eyesight.
W
indAge
And
e
leVATion
A
djusTMenTs
This Crossfire II riflescope incorporates adjustable elevation and
windage dials with audible clicks. Each audible click moves the bullet’s
point-of-impact 1/4 of a minute of angle (MOA).
1/4 MOA closely corresponds to 1/4 inch at 100 yards, 1/2 inch at 200
yards, 3/4 inch at 300 yards...taking four (4) clicks to move the bullet’s
point-of-impact approximately one inch at 100 yards.
How to adjust windage and elevation settings
Begin adjusting the windage and elevation settings by first removing
the outer covers. Then, move the
turrets in the direction you wish
the bullet’s point-of-impact to
change. To make the adjustments,
rotate the adjustment dial in the
appropriate direction (up/down
or left/right) as indicated by the
arrows.
After sight-in, you can re-align
the zero marks on the turret dials
with the reference dots if you wish
(see Indexing Adjustment Dials with Zero Reset on page 12). Replace the
outer covers when done.
Adjust the
Magnification.
Adjust the
reticle focus.
To adjust settings, rotate the dials.