Vortex Optics CROSSFIRE II 1X24 MUZZLELOADER SCOPE - Manual (Page 6)

11 10
RIFLESCOPE
II
Indexing Adjustment Dials with Zero Reset
The Crossfire II Muzzleloader features windage/elevation dials that
allow you to re-index the zero indicator after sight-in without disturbing
your settings. Though not required to do, this process will allow you to
quickly return to your original zero if temporary corrections are dialed
in the field. Reset the windage and elevation dials in this way:
1. Remove the outer
cap. While firmly
holding the dial, loosen
and remove center
screw.
2. Lift dial off of scope.
Orient dial to reposition
the zero mark on the
index line.
3. Install dial and
reinstall and tighten
center screw while
firmly holding the dial..
m
AintenAnce
Cleaning
This fully waterproof and fogproof Crossfire II riflescope requires very
little routine maintenance other than periodically cleaning the exterior
lenses. The exterior of the scope may be cleaned by wiping with a soft,
dry cloth.
When cleaning the lenses, be sure to use products, such as the Vortex
Fog Free cleaning products or Lens Pen, that are specifically designed for
use on coated optical lenses.
• Be sure to blow away any dust or grit on the lenses prior to wiping
the surfaces.
• Using your breath, or a very small amount of water or pure alcohol,
can help remove stubborn things like dried water spots.
Lubrication
All components of Vortex Crossfire II riflescopes are permanently
lubricated, so no additional lubricant should be applied.
Note: Other than to remove the turret caps, do not attempt to
disassemble any components of the riflescope. Disassembling of
riflescope may void warranty.
Storage
If possible, avoid exposing your Vortex riflescope to direct sunlight or
any very hot location for long periods of time.