Vortex Optics HIGH COUNTRY TRIPOD - Manual (Page 2)

©Vortex Optics USA 2011
K
H
Extending the leg length
Each tripod leg has five sections. To extend a leg, release
the flip-lever locks (K) and slide
leg sections out to the desired
length. Press the flip-lever back
down to lock a section in place.
Warranty and Service
This product is warranted to be
free of defects in materials and
workmanship for three years
after purchase. Vortex Optics
will repair or replace such
product or part thereof that,
upon our inspection, is found
to be defective in materials or
workmanship.
If you need assistance using your
tripod, please contact:
Vortex Optics
2120 West Greenview Drive
Middleton, WI 53562
800-426-0048
[email protected]
Adjusting the variable leg angle spread
Adjust the tripod leg angles for ease of use in
various scenarios. Push
the leg release button (H)
and lift the leg upward to
one of two different angle
positions. Repeat with
other legs as needed.
Adjusting the center column
Change the two-piece position of the center column (I) to
gain additional height. Unlock the center column by rotating
the collar (G) in a counter-clockwise direction. Maneuver
the center column to the desired height and lock in place by
rotating the collar in a clockwise direction.
S tabilize the tripod
in windy conditions by hanging a counterweight (not supplied)
from the center column accessory hook (J).
Remove the bottom section of the two-piece
center column to keep the head closer to the
ground when viewing at the lowest position.