Vortex Optics STX TRIPOD KIT - WITH RC 128 HEAD - Manual (Page 2)

©Vortex Optics USA 2009
E
Warranty and Service
This product is warranted to
be free of defects in materials
and workmanship for three
years after purchase. Vortex
Optics will repair or replace
such product or part thereof
that, upon our inspection,
is found to be defective in
materials or workmanship.
If you need assistance using
your tripod, please contact:
Vortex Optics
2120 West Greenview Drive
Middleton, WI 53562
800-426-0048
[email protected]
Adjusting the variable leg angle spread
Adjust the tripod leg angles for ease of use in various scenarios.
Push the leg release button in (E) and lift
the leg upward, setting it at one of the
three available angles. Repeat with other
legs as needed.
The legs on the STX tripod can be independently adjusted
to one of three viewing positions.
1. Thread the panhead onto the panhead mounting bolt (B) and
tighten until secure.
2. Extend the center column (G) above the locking collar (D)
and tighten the three set screws on the underside of the panhead
connector platform with an Allen wrench.
Attach a tripod head (sold separately) to the STX tripod legs in two steps:
Adding a tripod head