Bissell PRODRY 8350 - Manual (Page 8)

8
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
O
peration
Empty the dirty water tank
1. When the dirty water tank level reaches the FULL line,
when the float trips or when finished carpet cleaning,
turn power switch OFF ( O ).
2. Remove dirty water tank by lifting straight up
and carry it to the sink or wherever you plan to
dump the dirty water.
3. Remove the tethered cap on the rear of
the tank.
4. Pour out the dirty water, rinse tank and replace
the cap.
5. To continue carpet cleaning refer back to
page 7 beginning with "Fill the clean/solution
tank."
If cleaning is complete, refer to the “Maintenance
and care” section on page 11.
Pretreating (optional)
1. Pretreating (optional)
Pretreating is recommended to improve cleaning
effectiveness for heavily soiled carpet in high traffic
areas such as entry ways and hallways. Please keep
in mind that pretreating will wet the carpet and could
impact dry time.
To pretreat:
A. Using the BISSELL Tough Stain
Pre-cleaner, generously spray evenly over
soiled area, do not overwet.
B. Wait 3-5 minutes before cleaning.
C. Clean as normal using your BISSELL PROdry,
following the instructions on page 7.
Ready Tools™ (cleaning with attachments)
Your PROdry carpet cleaner comes equipped with
a hose and at least two attachments for cleaning
stairs, upholstery, stains and more.
Important! If using the machine to clean
upholstery, check upholstery tags.
1. Check manufacturer’s tag before cleaning. “W”
or “WS” on the tag means you can use your
PROdry. If the tag is coded with “X” or “S”
(with a diagonal strike through), or says “Dry
Clean Only,” do not proceed. Do not use on
velvet or silk. If manufacturer’s tag is missing
or not coded, check with your furniture dealer.
WARNING:
To reduce the risk of fire
and electric shock due to
internal component
damage, use only BISSELL
cleaning fluids intended for
use with the carpet cleaner.
Non-BISSELL cleaning
solutions may harm the
machine and void
the warranty.
Manufacturer’s tag
ug120-4080_7350_908.indd 8 10/14/08 1:25:59 PM