Bissell PRODRY 8350 - Manual (Page 9)

9
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Ready Tools™ (continued)
2. Check for colorfastness in an inconspicuous
place.
3. If possible, check upholstery stuffing.
Colored stuffing may bleed through fabric
when wet.
4. Plan activities to give upholstery time to dry.
5. Vacuum thoroughly to pick up loose debris and
pet hair. Use a vacuum with a brush attachment
and a crevice tool to clean in fabric folds and tufts.
6. To begin cleaning with attachments, follow
the instructions on page 7 for filling the
clean/solution tank.
7. Set the ReadyTools dial to the TOOLS setting.
This will allow for suction from the hose.
8. Attach the desired cleaning tool to the end of
the hose.
9. Clean by pressing the trigger to spray
solution onto the area to be cleaned. Slowly
move the tool back and forth over the soiled
surface. Release the trigger to suction dirty
water. Continue to clean in the area, working
in small sections, until dirt is removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove and rinse
tool(s) in clean, running water.
11. It is recommended that you suction clean
water from the tap to rinse out the hose.
12. Before wrapping hose onto tool rack, lift end
of hose and stretch out to ensure all water is
cleared from hose.
13. Wrap flex hose around tool rack.
14. Empty collection tank and rinse out,
following instructions on page 10.
15. If the ReadyTools dial becomes difficult to
turn, the diverter assembly that holds the dial
may need to be cleaned. To clean, flush hot
water through the nozzle. Make sure the dial
is set to FLOOR CLEANING.
O
peration
ug120-4080_7350_908.indd 9 10/14/08 1:25:59 PM