Wasp Barcode WDI4600 2D Product Reference Guide - Manual (Page 181)

Product Reference Guide 171
2D SYMBOLOGIES
2D Global Features
• 2D Maximum Decoding Time, page
172 • 2D Normal/Inverse Symbol Control,
page 173
• 2D Structured Append, page 173
The reader supports the following 2D symbologies (barcode types). Symbology-dependent
options for each symbology are included in this chapter. See
"1D Code Selection" starting on
page 79 for configuration of 1D barcodes.
2D Symbologies
• Aztec Code, page 174 • Micro PDF417, page 189
• China Sensible Code, page 177 • QR Code, page 192
• Data Matrix, page 180 • Micro QR Code, page 195
• Maxicode, page 183 • UCC Composite, page 198
• PDF417, page 186 • Postal Code Selection, page 200
2D Global Features
The following features are common to all, or in some cases, most of the available 2D
symbologies. Default settings are indicated at each feature/option with a green arrow. Also
reference
Appendix B, Standard Defaults for a listing of the most widely used set of standard
factory settings. That section also provides space to record any custom settings needed or
implemented for your system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING barcode at the top of applicable program-
ming pages.
2. Scan the correct barcode to set the desired programming feature or parameter. You may
need to cover unused barcodes on the page, and possibly the facing page, to ensure that
the reader reads only the barcode you intend to scan.
3. If additional input parameters are needed, go to Appendix D, Keypad , and scan the
appropriate characters from the keypad.
Additional information about many features can be found in the “Refer-
ences” chapter.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Complete the programming sequence by scanning the ENTER/EXIT PROGRAMMING
barcode to exit Programming Mode.