Wasp Barcode WDI4600 2D Product Reference Guide - Manual (Page 54)

Enter/Exit Programming Mode Data Format
44 WDI4600
Global Prefix/Suffix
This option sets up to 20 characters each from the set of ASCII characters or any hex value from
00 to FF. The characters may be added as a prefix (in a position before the barcode data, also
called a header) and/or as a suffix (in a position following the barcode data, also called a footer).
See
page 219 for more detailed instructions on setting this feature.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode above
to place the unit in Programming Mode, then the “Set Global Prefix” or “Set Global Suffix,”
barcode followed by the digits (in hex) from the Alphanumeric characters in
Appendix D,
Keypad representing your desired character(s). If less than the expected string of 20 characters
are selected, scan the ENTER/EXIT barcode to terminate the string. Exit programming mode
by scanning the ENTER/EXIT barcode again.
$CLFPR
Set Global Prefix
$CLFSU
Set Global Suffix
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning. ~
CANCEL
DEFAULT No Global Prefix
Global Suffix = 0x0D (CR)