Wasp Barcode WLS8600 Quick Reference Guide - Manual (Page 14)

Programming
10 WLS8600
Programming
The reader is factory-configured with a set of standard default features. After scan-
ning the interface barcode from the Interfaces section, select other options and cus-
tomize your reader through use of the programming barcodes available in the
WLS8600 Reference Manual. Check the corresponding features section for your
interface, and also the Data Editing and Symbologies chapters of the PRG.
Restore Default
Restore Default
Ì$+$*oÎ
To change the settings refer to the WLS8600 Reference Manual.
Data Format Terminators
For your convenience, some common Terminators are given below. For other
Header/Terminator selections, Data Format and Advanced Data Format parame-
ters, see the WLS8600 Reference Manual.
Operating Test
Read the TEST code below.
Code 128
CR-LF
Ì$+EA120D0A$-ÃÎ
Enter
Ì$+EA1183$-0Î
Tab
Ì$+EA1184$-8Î
None
Ì$+EA10$-dÎ
t e s t