Wasp Barcode WLS8600 Quick Reference Guide - Manual (Page 18)

Compliance
14 WLS8600
LED CLASS
Class 1 LED product.
CE Compliance
FCC Compliance
Modifications or changes to this equipment without the expressed written approval
of Datalogic could void the authority to use the equipment.
This device complies with PART 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference which
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Op-
eration of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own ex-
pense.
Power Supply
This device is intended to be connected to a UL Listed/CSA Certified computer
which supplies power directly to the reader or else be supplied by a UL Listed/CSA
Certified Power Unit marked “Class 2” or LPS power source rated 4 - 30 V, minimum
420 mA, which supplies power directly to the reader via the power connector of the
cable.
WARNING
This is a Class A product. In a domestic environment this product
may cause radio interference in which case the user may be
required to take adequate measures.