Waterpik WP-900 Owners Manual - Manual (Page 10)

10
1. Use coin or washer to rotate cap counter-
clockwise until cap protrudes.
2. Push down hard with shaft on hard surface.
3. Remove cap and pull internal body out.
Cut tape and remove.
4. Lift battery pack up and cut battery wires,
one at a time, to free from circuit board.
Cleaning
1.
After each use,
turn off unit, remove
the brush head from
the handle and rinse
brush head under
running water.
2. Wipe the handle dry after each use.
Service
Waterpik
® toothbrushes have no consumer
serviceable or replaceable electrical items and do
not require routine service maintenance. For all
accessories go to www.waterpik.com.
You may also call our toll-free customer service
number at 1-800-525-2774.
Refer to the serial and model numbers in all
correspondence. These numbers are located on
the bottom of your unit.
Disposal
This product contains rechargeable Nickle Metal
Hydride batteries. The batteries are not replaceable.
Please do not dispose of the unit in the household
waste. Remove the batteries per the instructions
below and recycle at your local recycling center.
Battery Removal
Note: This process is not reversible
Remove the battery only at the end of the product’s
life for recycling. Doing so earlier will destroy the
product. Deplete the battery charge until the brush no
longer operates. Observe basic safety precautions.
Remove the batteries as shown and recycle them and
the rest of the product according to local regulations.
Tape
CARE OF yOUR SENSONIC ® PROFESSIONAL PLUS TOOTHBRUSH