Weidmuller WAVE Analog DC/DC - Manual (Page 3)

10
1. General instructions
Warning! Analouge signal isolators from the WAVE
ANALOGUE
range should
only be installed by qualified staff. Auxiliary power should only be
supplied after the device has been installed by qualified staff.
National standards and regulations (e. g., DIN VDE 0100 in Ger-
many) must be observed when selecting and installing supply
conductors.
Protective measures must be taken against electrostatic dischar-
ges (ESD) when installing and setting WAVE
ANALOGUE
devices.
2. Application
Analouge singnal isolators are used for galvanic isolation and conversion of
0.4 mA and 10 V standard signals. Input and output signals are factory set
according to type. It is not necessary to adjust the measurement range.
The transmitted measurement signal is linear.