Weidmuller WAVE Analog PRO RTD User Manual

Page 4

Advertising
background image

17

3. Configuration

3.1 Equipment
A screwdriver with a width of 2.5 mm is required to adjust the unit and to
connect the wires to the terminals.

3.2 Opening the unit
Disconnect the plugs. Disengage the top part of
the housing by carefully pressing the latches on
both sides (1). Pull out the top part of the hous-
ing and the electronics section until they lock (2).

3.3 Settings
Set input and output ranges, minimum input values
and measuring span via the DIP switches SW1 and
SW2 according to the following tables.
When activating variable setting SW 1/8 of the span
or offset, it is possible to make additional adjust-
ments via front potentiometers span and offset,
accessible below cover (3)

Caution!

Only use a screwdriver which is
properly insulated against the voltage
applied to the input when fine adjusting
the potentiometers on the front.

1

1

2

Zero

Span

SW2

SW1

3

Advertising