Weidmuller WAVE Analog PRO Thermo - Manual (Page 3)

16
1. General instructions
Achtung! The analogue signal isolators of the WAVE
ANALOGUE PRO
series
may only be installed by qualified personnel. Be sure not to con-
nect the unit to power supply before appropriate installation. Do
not select ranges during operation, because live parts are expo-
sed during this process. Only use a screwdriver which is proper-
ly insulated against the voltage applied to the input when fine
adjusting the potentiometers on the front.
Be sure to observe the national regulations for installation and
selection of cables.
Appropriate safety measures against electrostatic discharge
(ESD) should be taken during assembly and adjustment work on
the WAVE
ANALOGUE PRO
.
2. Application
Analouge singnal isolators are used for galvanic isolation and conversion of
thermoelement signals. Input and output signals are factory set according
to type or can be calibrated/switched via DIP switches. It is not necessary
to adjust the measurement range. A +/- 5% variation can be achieved in
the respective range by connecting potentiometers for zero and span. The
transmitted measurement signal is linear to be measured temperature.