Weidmuller Thermo Signal Conditioners for current & voltage output - Manual (Page 4)

18
3.3 Pluggable cross-connections for voltage supply
(s. Fig. 3)
A maximum feed through of 2 A is possible.
If a signal conditioner is accidently rotated through 180°, the
cross-connection cannot be inserted.
3.4 Labelling possibilities
(s. Fig. 4)
WS 10 connector markers can be used to label module.
4 Calibration
Warning!! The power supply must be disconnected, before
changing the signal conditioner settings using the
DIP switches.
Failure to observe will lead to considerable damage!
Note!! The module calibrates itself, when using the DIP
switches on the printed circuit board to set the
temperature range.