Hardware installation procedure – Weidmuller IE-CS(T)-2TX Series - Industrial Ethernet Serial/Ethernet Converter User Manual
Page 4
Serial/Ethernet Converter LED Indicators (front panel)
Name Color
Function
PWR1,
Power is being supplied to power input PWR1
or PWR2
PWR2
Red
Red
Serial/Ethernet Converter is
Blinking:
Steady on: Power is on and the
booting up.
Indicates an IP conflict, the
DHCP or BOOTP server did not
respond properly, or a relay
output occurred.
green
Steady on:
r
e
n.
Power is on and the
Serial/Ethernet Converter is
functioning normally.
Blinking:
The Serial/Ethernet Converte
has been located by th
Administrator’s "Locate" functio
Ready
off
Power is off
n exists.
, or a power error conditio
orange 10 Mbps Ethernet connection.
green 100 Mbps Ethernet connection.
E1, E2
or has a
off
Ethernet cable is disconnected,
short.
Serial port is receiving data.
orange
green
ort is transmitting data.
Serial p
P1, P2
r received
off
No data is being transmitted o
through the serial port.
. Hardware Installation Procedure
1: After removing the Serial/Ethernet Converter from the box,
ct the 12-48 VDC
STEP 2:
STEP 3:
l
4
STEP
first connect the power adaptor. Conne
power line with the terminal block, or connect the DIN-Rail
power supply with the Serial/Ethernet Converter’s terminal
block.
Connect the Serial/Ethernet Converter to a network. Use a
standard straight-through Ethernet cable to connect to a Hub
or Switch. When setting up or testing the Serial/Ethernet
Converter, you might find it convenient to connect directly to
your computer’s Ethernet port. Use a cross-over Ethernet
cable If the PC don’t support autocrossing.
Connect the Serial/Ethernet Converter’s serial port to a seria
device.
STEP 4: The Serial/Ethernet Converter is designed to be attached to a
DIN-Rail or mounted on a wall. For DIN-Rail mounting, push
down the spring and properly attach it to the DIN-Rail until it
“snaps” into place. For wall mounting, install a wall mount kit
first, and then screw the device onto the wall. The following
figure illustrates the two mounting options:
- 4 -