Western Digital WD Sentinel RX4100 User Manual - Manual (Page 94)

MANAGING ISCSI STORAGE
88 WD SENTINEL RX4100
ADMINISTRATOR AND MAINTENANCE GUIDE
Disable an iSCSI Target
Note: Disabling your iSCSI Target temporarily suspends the target, but does not remove it.
If you’d like to permanently remove the target, See “Deleting an iSCSI Target” on
page 89.
1. In the iSCSI tab, select the target you’d like to disable.
2. In the iSCSI Tasks pane, click Disable Target. The Disable a Target message appears.
3. Click Disable Target. Disabled now displays in the Status column.
Enabling an iSCSI Target
1. In the iSCSI tab, select the disabled Target you’d like to enable.
2. In the iSCSI Task pane, click Enable Target. Your target is now enabled.