WORX WU303.1 900W Hammer Drill 240V. 2 Speed 13mm Keyless Chuck - Manual (Page 8)

8
1
2
3
4
5
Operating instructions
Note: Before using the tool, read the instruction book carefully.
INTENDED USE
The machine is intended for impact drilling in brick, concrete and stone as
well as for drilling in wood, metal and plastic. Machines with electronic
control and right/left rotation are also suitable for thread-cutting.
ON/OFF SWITCH
Depress to start and release to stop your tool.
SWITCH LOCK-ON BUTTON
Depress on/off switch (1) then lock on button (2) (See A), release
on/off switch first and lock-on button second. Your switch is now
locked on for continuous use. To switch off your tool just depress and
release the on/off switch.
FORWARD AND REVERSE ROTATION CONTROL
For drilling use forward rotation marked “
”(lever is moved to the
left). Only use reverse rotation marked “ ”(lever is moved to the
right) to release a jammed drill bit.
Never change the direction of rotation when the tool is
rotating, wait until it has stopped.
HAMMER OR DRILLING CONTROL
When drilling masonry and concrete choose the Hammer position
When drilling wood, metal, plastic choose the Drill position. (See B)
HAMMER DRILL LOCKING BUTTON
To change between the hammer and drilling selection positions you
must push the locking button in before rotating the selector to the
1
2
A B
C D.1
D.2