WORX WU303.1 900W Hammer Drill 240V. 2 Speed 13mm Keyless Chuck - Manual (Page 9)

9
chosen position, ensuring that the button springs back out to lock the
selector when the chosen position is reached. (See B)
AUXILIARY HANDLE
Slide the handle onto the drill and rotate to the desired working
position. To clamp the auxiliary handle rotates the handgrip clockwise.
To loosen the auxiliary handle rotate the hand grip anti-clockwise.
Always use the auxiliary handle (See C).
DEPTH GAUGE
Fit the drill bit or driver bit into the chuck. Loosen the depth gauge by
rotating the handle grip anti-clockwise. Slide the depth gauge until the
distance between the depth gauge end and the drill/driver bit end is
equal to the depth of hole/screw you wish to make. Then clamp the
depth gauge by rotating the handle clockwise.
INSERTING TOOLS
KEYLESS CHUCK (WU303.1 WU303L)
Grip rear collar of keyless chuck and rotate front collar until chuck is
open sufficient for tool to be inserted. Insert the tool into the chuck.
Grip rear collar and manually rotate front collar until tight. The locking
mechanism is automatically released when the front collar is rotate in
the opposite direction in order to remove the tool. (See D.1)
KEY CHUCK (WU303)
Insert tool and tighten equally in all 3 bores with chuck key. (See D.2)
SPEED CHANGE KNOB
Choose position 1 for high torque/low speed range for large diameter
drill bits and screw driving. Choose position 2 for low torque/ High-
speed range for small diameter drill bits. If the gears do not engage
easily then rotate the chuck by hand to align the gears. Never change
the gears when the tool is rotating, wait until it has stopped.
6
7
8
9
1
2
A B
C D.1
D.2