WORX WU469 600W Contour Jigsaw 240V - Manual (Page 10)

10
1
2
Operating instructions
Note: Before using the tool, read the instruction book carefully.
INTENDED USE
The machine is intended for sawing wood, plastic, metal and
building materials while resting firmly on the workpiece. It is
suitable for straight and curved cuts with mitre angles to 45°. The
saw blade recommendations are to be observed.
ON/OFF SWITCH (See Fig. A)
The tool is switched on by the switch button located at the side
of the motor housing. The switch locks in the on position, a
convenience for continuous operation.
TO TURN ON THE TOOL on slide the switch button forward.
TO TURN OFF slide the switch button backward.
VARIABLE SPEED CONTROL (See Fig. B)
Adjust the Variable speed control to increase or decrease the
speed according to the material, material thickness and blade
specification to be used (also possible during no load operation).
See Chart 1 for general guidance on speed selection. Avoid
prolonged use at very low speed as this may damage your jigsaw’s
motor.
1 3
B A