WORX WU469 600W Contour Jigsaw 240V - Manual (Page 11)

11
Chart 1
Material Speed setting
Wood 5-6
Metal 3-4
Aluminum 3-5
PVC 3-4
Ceramic 3-5
HAND GRIP AREAS
Always ensure you maintain a firm grip whilst operating your
jigsaw. Your hand must hold on the handle when you are working.
BLADE FITTING (See Fig. C, D)
You can only use the blade type shown in Fig C. To open the blade
holder rotate the ring anti-clockwise (jigsaw upside down) and hold
in position (See Fig. D). Then fully insert the blade into the blade
holder slot with blade teeth facing forward and release the ring,
which will self rotate and clamp over the top of the blade. Push the
blade into the blade holder again to ensure it is locked in position.
Ensure the edge of the blade is located in the groove of the blade
guide. To remove a blade, hold the blade and rotate the blade
holder ring anti-clockwise then lift out the blade (blade could be
spring ejected).
Warning: Blade teeth are very sharp. For best cutting
results ensure you use a blade suited to the material and cut quality
3
4
D C