Brother HL 5370DW - Manual (Page 128)

Troubleshooting
118
7
Error message printout
7
The printer can also report problems by printing an error message. Use the table below to identify and clear
the error message. The default setting for the error message printout is off. If you want to turn the error
message printout on, from the Advanced tab of the Windows
®
printer driver click the Other Print Options...,
and then choose Error Message Printout.
Error message Action
Memory Full „ Press Go to print the remaining data in the printer memory. Cancel the print job
if you want to delete the remaining data in the printer memory. See Control panel
buttons on page 84.
„ Reduce the complexity of your document or cut the print resolution.
„ Add more memory. See Installing extra memory on page 91.
Print Overrun „ Press Go to print the remaining data in the printer memory. Cancel the print job
if you want to delete the remaining data in the printer memory. See Control panel
buttons on page 84.
„ If this does not clear the error, reduce the complexity of your document or cut the
print resolution.
„ Add more memory. See Installing extra memory on page 91.
„ Set page protection to Auto by using the supplied Windows ® driver or the control
panel.
„ Change the following settings in the supplied Windows ® driver and try again. The
best combination of these settings will vary depending on your document:
„ Graphics
1
„ TrueType Mode 1
„ Use Printer TrueType ® Fonts
1 Choose the Basic tab, choose Manual in Print Settings, and then click Manual Settings....
Resolution Adapted „ Reduce the complexity of your document before you print to prevent automatic
reduction in the resolution.