Yamato Scientific CLH600 Cool Line - Manual (Page 20)

17
Operation Method
Fixed Temperature Operation
In this mode, the unit starts to operate by pressing RUN/STOP key and continues operating at the
set temperature until RUN/STOP key is re-pressed, as shown in the figure below.
温度（℃）
時間（t）
SV:温度設定値
SV
ｽﾀｰﾄ/ｽﾄｯﾌﾟ ｷｰON ｽﾀｰﾄ/ｽﾄｯﾌﾟ ｷｰOFF
Fixed temperature
operation procedure
1. Turn on the power (turn on the breaker in front)
™ Current version of the software is displayed for about four seconds
after turning on the power. The screen then displays the initial
setting. The current temperature in bath, operation mode
character and setting temperature of overheating prevention device
are displayed on respective screens.
2. Select the operation mode
• Press the FIXED TEMP key to display "FIX", which indicates
the fixed temperature operation, on the center display screen.
3. Set the temperature
① Press the FIXED TEMP key again.
The setting temperature screen displays the character "Sv"
which indicates the temperature setting. Also it displays the
current setting temperature with blinking. The FIXED TEMP
lamp blinks, too.
② Set the temperature by pressing the "▼▲".
The temperature can be set to the first decimal place.
Measurement temperature screen:
Displays the current temperature in bath.
Setting temperature screen:
Displays the operation mode character. (Refer to Page 13)
Overheating prevention screen:
Displays the setting temperature of overheating prevention device
TEMP
RUN/STOP key: ON RUN/STOP key: OFF
TIME
SV: Set Temp.
①
②