Yamato Scientific IN803 Low Temperature Incubators - Manual (Page 27)

23
Operation Method
Auto Start Operation
3 Set temperature and start wait period/time
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Set TEMP 0.0℃
Auto-start OPR
REFRIGE
DEFROST
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Set TEMP 37.0℃
Auto-start OPR
REFRIGE
DEFROST
①
The setting temperature input screen is
displayed. The Sub Display indicates "Set
TEMP" and the numeric character that indicates
temperature blinks.
② Set the temperature using the "▲▼".
③ Press the ENTER key to decide the temperature.
④ The operation start wait period/time input screen
is displayed after the setting temperature is
decided.
Display the operation start wait period/time using
the "▲▼".
Input the operation start wait period when the
setting of timer mode shows "Time". Input the
operation start time when it shows "Clock".
Wait ST 30min
Auto-start OPR
Start Time 13:00
Auto-start OPR
(Operation start wait
period edition screen)
(Operation start time
edition screen)
• The display style of operation start wait period
varies depending on the range of time to be
displayed.
Time Range Indication
0minute to 59minutes 0min to 59min
1hour to
99hours59minutes
1h00m to 99h59m
• The input range of operation start time is always
from 0:00 to 23:59.
™ Pressing the CANCEL key quit the setting of auto
start operation.
4 Start operation
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Set TEMP 100℃
Start in 30min
REFRIGE
DEFROST
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Set TEMP 37.0℃↑
2002/01/01 12:30
REFRIGE
DEFROST
①
Press the ENTER key to decide the operation
start wait period/time. The unit enters to auto
start operation wait state. The blinking AUTO
START lamp lights on and the STANDBY lamp
blinks instead in this state. The Sub Display
displays the setting temperature and residual
time to operation start.
② The operation starts when the residual time
counts zero. The STANDBY lamp lights off and
the Sub Display displays the same subject as in
the fixed temperature operation after the
operation starts.
③ Press the POWER key to cancel or quit the wait
state.