Yamato Scientific RE400 Evaporators, Rotary - Manual (Page 10)

8
How to Assemble
6. Fit the cooling tube holder shaft (glass type B and C only)
Fit the cooling tube holder shaft firmly into the screw hole on the back of motor. Put the attached
hexagon wrench through the hole on the end, and fasten tight.
7. Fit the cooling tube holder and joint the cooling tube with the connecting
pipe.
Joint the cooling tube to the connecting pipe, and hold by cooling tube clamp. Then, pass the cooling
tube holder from top of the cooling tube, while fitting the other side hole to the holder shaft. Level and
fix the positions by attached butterfly nut. (In case of C type, pass the cooling tube holder from
bottom over the cooling tube and joint it to the connecting pipe.)
＊ ＊ ＊ ＊Wipe the flanges well before you joint the cooling tube to connecting pipe.
Put the suction cock for B type or the cooling tube lid for C type.
Cooling Tube Clamp
Holder
Suction Cock
Lid