Yamato Scientific SQ 510 Autoclave, Sterilizers - Manual (Page 8)

5
Cautions in Using with Safety
Fundamental Matters of "WARNING!" and "CAUTION!"
When taking the sterile samples from the chamber...
Sufficiently remove the vapor inside the chamber before taking the sterile samples from the chamber.
Wear heat-resistant leather gloves to take them from the chamber to protect your hands from
high-temperature samples.
Do not touch the heat releasing outlet
Do not directly touch the heat releasing outlet located around the outer covering. The vapor may blow
out from the safety valve by an accident during sterilizing operation. Do not block the outlet.
During a thunder storm
During a thunderstorm, turn off the power key immediately, then turn off the circuit breaker and the main
power. If this procedure is not followed, fire or electrical shock may be caused.
When power failure occurs...
The lock lever on the cover goes into locked state for safety reasons when the power is turned off due
to a power failure. The state is automatically cancelled when the power is turned on and the pressure
inside the equipment decreases.
Do not operate the equipment without supplying sufficient amount of water
Do not operate the equipment without supplying sufficient amount of water. The heater is exposed to
the open-air if the amount of water supplied is insufficient, which causes a deterioration or breakage of
equipment. Make sure before operation that the appropriate amount of water is supplied inside the
chamber. (Refer to 9 of “Pour water into the chamber” in Page 11 for details.)
Do not open the panel on the outer covering
Touching the interior portion of equipment may cause an electric shock, burn injury, fire disaster or
equipment failure.
Do not touch the power plug with a wet hand
An electric shock may result in.
Do not place your hand over the top board
The hand may be stuck in the cover and injured.