Warning, Caution, Aintenance and care – Bissell 6221 User Manual

Page 10

Advertising
background image

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1

M

aintenance and care

10

Cleaning and replacing

the pre-motor filter

use only genuine bissell replacement filters

in your Velocity bagged vacuum.
1. unplug the cleaner from electrical outlet.
2. Remove the bag tank and vacuum bag

as described on page 9.

3. the pre-motor filter is located inside the bag

tank. Remove the filter and its plastic cage.

separate the filter from the cage and wash

by hand in warm water. Mild detergent

may be used if desired. Rinse well, then

air dry thoroughly before replacing the

pre-motor filter.

Replacing the post-motor filter

use only genuine bissell style 9 (#32076)

replacement filters in your bissell Velocity

bagged vacuum.
1. unplug the cleaner from electrical outlet.
2. the post-motor filter assists in the filtration

process to return clean air to the room. it

is located behind the door on the side of

the vacuum. When the filter becomes dirty,

open the door, remove the filter and replace.

the white, pleated hepa Media filter* is

not washable.

Check rotating floor brush

and drive belt

You should check your vacuum cleaner's rotating

floor brush and drive belt regularly for wear or

damage. You should also clean the brush tand

brush ends of string, hair, and carpet fibers.

these can wrap around the brush and hamper

its ability to effectively clean your carpet. also

remove any debris that has accumulated under

the brush cover.
1. unplug the cleaner from electrical outlet.
2. place handle in low position and turn

vacuum cleaner over so bottom side is up.

3. Remove the five screws with a phillips-head

screwdriver. lift the brush cover off.

Post-Motor

Filter

WARNING:

Do not operate cleaner with

damp or wet filters or without

all filters in place.

CAUTION:

To reduce the risk of injury from

moving parts, turn off vacuum

cleaner and disconnect Power

Plug from electrical outlet.

Brush Cover

3.

*the filter media, not the vacuum as a whole, complies with

the iest-Rp-cc001.5 or the en-1822-1:2009 hepa standard.

3.

Advertising