Bissell 6221 - Manual (Page 5)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
A
ssembly
5
2.
2.
Hose
Wand
Base
the only tool you’ll need to assemble your
vacuum cleaner is a phillips-head screwdriver.
Attach handle to vacuum
1. locate the vacuum handle and
remove the screw packet taped to it.
2. stand the vacuum upright and slide
the base of the handle firmly into the
grooves at the top of the vacuum body.
3. check to be sure the handle is fitted
to the vacuum body. if there is a gap
in front, continue to push firmly until
the handle is flush.
4. insert the screw provided from the
screw packet into the existing hole.
tighten securely with a screwdriver.
Attach vacuum hose and tools
1. attach the twist ‘n snap™ hose by
lining up the tabs on the base with the
corresponding notches on the back of
the vacuum.
2. turn the twist ‘n snap hose to the
right to lock the hose into place.
3. grasping the Quick Reach handle,
slide the end of the hose wand onto
the hose wand base. snap the hose
into the hose clip.
NOTE: The Powerfoot will not
suction properly unless the hose
wand is firmly attached.
4. snap the extension wand and
the crevice tool together into the
storage clip.
5. snap the combination tool into the
storage clip.
6. attach the turbobrush tool by
aligning the small holes near the
brush roll with the tabs at the bottom
of turbobrush tool housing. snap
turbobrush tool into place.
6.
4.
3.
4.
4.
5.