Warning, Lighting instructions, Lighting the main burners – Brinkmann 2210 Series User Manual

Page 11: Match lighting the main burners, Lighting hole matchlighter

Advertising
background image

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.

1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside

the grill. An explosion could occur if grill lid is down.

2. Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.

3. Turn on the fuel supply by rotating the cylinder valve knob counter-clockwise to full open.

4. DO NOT stand with head, body, or arms over the grill when lighting.

LIGHTING THE MAIN BURNERS:

1. Open lid before lighting burner.

2. Make sure all control knobs are in the "OFF" position.

NOTE: The CENTER BURNER must be lit first, then light the left and right burners.

3. Push and turn the control knob for the CENTER BURNER to the

"HIGH" position.

4. Press the electronic igniter and hold for 3–5 seconds to light burner.

5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF",

wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

6. If the CENTER BURNER does not ignite using the push-button igniter,

wait 5 minutes, see "Match Lighting the Main Burners" section.

7. To light the left and right burners, push and turn control knobs to HIGH.

Follow Step 5.

8. To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off the

gas flow from the cylinder.

NOTE: If burner does not light or flame is too low, you may have spider or other insect blockage in burner,

or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper
Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and
Hose/Regulator to Grill.

MATCH LIGHTING THE MAIN BURNERS:

1. Open lid before lighting.

2. Turn the burner control knobs to "OFF".

3. Place a paper match in the end of the matchlighter. Strike the

match and place through lighting hole in the left hand side of the
grill to approximately 1/2" (1 to 2 cm) from the burner.

4. Turn on the FAR LEFT burner control knob to the "HIGH"

position. The burner should light within 5 seconds.

5. If the burner does not light, turn the control knob to "OFF" and

wait 5 minutes for gas to dissipate and repeat lighting procedure.

6. Once lit, light adjacent burners in sequence by pressing in and

rotating the control knob to the "HIGH" position.

7. If the burner does not light within the first few attempts of match lighting, there is a problem with the

gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected. See "Trouble Shooting" section of this manual.

WARNING

10

WARNING

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip
any of the warnings and instructions contained in the preceding sections of this manual.

ELECTRONIC IGNITER

FOR

CALL

FOR

US

BURNER

CENTER

7. To light the left and right

burners, push and turn
control knobs to HIGH.
Follow Step 6.

8. Refer to owner’s manual

for match lighting
procedure.

9. To turn off, turn each

control knob clockwise
until it locks in OFF
position.

NOTE: Turn off LP supply
at

cylinder

when

appliance is not in use.

GRILL LIGHTING INSTRUCTIONS:

1. Read and follow all warnings

and instructions in owner’s
manual before lighting.

2. Open lid before lighting burner.

3. Make sure all control knobs are

in the OFF position.

NOTE: The CENTER BURNER must

be lit first, then light the left and
right burners.

4. Push and turn the control knob for

the CENTER BURNER to HIGH.

5. Press the electronic igniter and

hold for 3-5 seconds to light burner.

6. If ignition does not occur in

5 seconds, turn control knob

to OFF, wait 5 minutes to allow gas
to dissipate and repeat lighting
procedure.

Lighting Hole

Matchlighter

Advertising