Brinkmann 2210 Series - Manual (Page 31)

7. To
ligh
t the
left
and righ
t
bu rne rs , pu
sh and
turn
co nt ro l k no bs to
HI GH.
Fol low S
tep 6 .
8. R
efer t
o owner’
s m anu
al
for match
li ghti
ng
proc
edure.
R b f or GH . igni
ter a
nd
ond s to light b
urne
r.
does n
ot oc
cur in
on ds, turn
con
trol kn
ob
o O FF, w ait 5
m inute
s to
allow g
as
to d
issipat
e and r
ep ea t lig hting
pro cedure.
30
Step 21
Remove igniter cap and insert
battery with positive end of battery
toward igniter cap. Replace igniter
cap and make sure the igniter is
working properly.
Igniter Cap Battery
ELECTRONIC IGNITER
FOR ASSISTANCE, CALL 800-527-0717
FOR OUTDOOR
USE ONLY
BURNER CENTER
7. To light the left and right burners, push and turn
control knobs to HIGH.
Follow Step 6.
8. Refer to owner’s manual for match lighting
procedure.
9. To turn off, turn each control knob clockwise
until it locks in OFF
position.
NOTE: Turn off LP supply
at cylinder when
appliance is not in use.
GRILL LIGHTING INSTRUCTIONS:
1. Read and follow all warnings
and instructions in owner’s manual before lighting. 2. Open lid before lighting burner.
3. Make sure all control knobs are
in the OFF position.
NOTE: The CENTER BURNER must be lit first, then light the left and
right burners.
4. Push and turn the control knob for the CENTER BURNER to HIGH.
5. Press the electronic igniter and hold for 3-5 seconds to light burner.
6. If ignition does not occur in
5 seconds, turn control knob to OFF, wait 5 minutes to allow gas
to dissipate and repeat lighting
procedure.
ProSeries 2210 (Assembled)