Black & Decker TL10 - Manual (Page 6)

ASSEMBLY INSTRUCTIONS
UNPACKING - (FIGURE B)
Remove the frame / upper handle assembly, mid handle,
ballast tank, wheels, drag bar, tines and hardware bag
from the carton.
The hardware bag contains:
1. Long Carriage Bolts (2)
2. Short Carriage Bolts (4)
3. Flanged Hex Nuts (4)
4. Knobs (2)
5. Wheel Machine Bolts (2)
6. Wheel Washers (4)
7. Steel Pin (1)
8. Long Hairpin Cotter Pin (2)
9. Short Hairpin Cotter Pin (1)
ASSEMBLY
DANGER: To prevent serious personal injury, do not connect electric
extension cord to unit until fully completing assembly.
Tools required for assembly:
Adjustable or 10 mm wrench
MID HANDLE ASSEMBLY - (FIGURE C)
Ensure that the cord is not pinched and is routed on the top side of the handles.
1. Align the holes in the mid handle with holes in the frame and insert the
short carriage bolts (C-1) through the holes.
2. Place a nut (C-2) on each bolt and tighten securely with a 10 mm or
adjustable wrench.
UPPER HANDLE ASSEMBLY - (FIGURE D)
Ensure that the cord is not pinched and is routed on the top side of the handles.
1. Align the holes in the upper handle with holes in the mid handle and
insert the long carriage bolts (D-1) through the holes.
2. Hand tighten plastic knob (D-2) onto carriage bolts.
3. Clip the lower part of the cord into the lower cord clip (D-3) after the
handles are fastened together.
B
C
3
D
6