AJA FS2 Quick Start - Manual (Page 7)

1
7 FS2 Quick Start Guide — Quick Workflows
SDI 1 Test
Signal Outputs The following two workflows produce bars and tone outputs and ramp and silence outputs
The setup is:
• Test signals are switched in at the FS2 outputs, so no particular input settings are
required.
The parameter settings are:
• No settings required.
Menu operations for SDI 1 Out Bars and Tone:
1. Press the Video 1 button.
2. Select 3 Video 1 Output Mode, and adjust to Test Pattern.
3. Select 21 Video 1 Test Pattern Video and adjust to 75% Bars.
4. Press the Audio 1 button.
5. Select 4 Audio Signal Gen and adjust to 1 kHz tone.
Menu operations for Ramp and Silence:
1. Press the Video 1 button.
2. Select 3 Video 1 Output Mode, and adjust to Test Pattern.
3. Select 21 Video 1 Test Pattern Video and adjust to Ramp.
4. Press the Audio 1 button.
5. Select 4 Audio Signal Gen and adjust to Off.