AJA RD5CE - Manual (Page 6)

6
Installation
Typically, RD5CE installation consists of the following:
1. disconnect power from the frame (remove line cord)
2. remove the FR1/FR2 front panel
3. install RD5CE card module
4. replace the FR1/FR2 front panel
5. apply power to the frame by connecting a north american-style power cord
from the frame to mains power (90 to 260 VAC)
!
Warning!
Ensure Mains Power is disconnected before installing the FR1 or FR2 frame R-
series modules into the frame, or installing and removing options. If a Mains
switch is not provided, the power cord(s) of this equipment provide the means of
disconnection. The socket outlet must be installed near the equipment and must
be easily accessible.
Warning!
FR2 Dual Power Cord Notice—please read this. To reduce the risk of electrical
shock, disconnect both power cords before servicing equipment.
Caution!
The FR1/FR2 front fan door is heavy and is not hinged. Remove with Caution.
Instructions for removing the frame front door for module installation is
discussed in the FR1/FR2 User Manual.
Specifications
Item Specification
Inputs: 2 Channels SDI (SMPTE 259M), 2x BNC
Outputs: CH 1: YPbPr-SMPTE, EBU-N10, Betacam, RGB, NTSC/PAL, YC
(S-Video)
CH 2: NTSC/PAL, Y, 1x BNC, SDI Looping Output, 2x BNC
Frequency Response: +/- .25dB to 5Mhz Y
+/- .25dB to 2.5Mhz C (Component)
+/- .25dB to 1.3Mhz C (Composite)
<1.5% Differential Gain
<1.5 Degree Differential Phase
User Controls: Dipswitch (Separate Control For Each Channel)
Video Format
Pedestal
H/V Blanking
Size: Fits AJA R-Series Frames
Compatible With Leitch® 6800 Series Frames
Power Consumption: 7.5 watts