B&D Mfg HSS - Manual (Page 2)

2
***CUSTOM TANKS MADE TO ORDER*** ***CUSTOM TANKS MADE TO ORDER*** ***CUSTOM TANKS MADE TO ORDER*** ***CUSTOM TANKS MADE TO ORDER***
IT’S FINALLY HERE A HYDRONIC BUFFER TANK WITH THE PUMPS, CONTROLS AND VALVES
ALL IN ONE. NO MORE HASSLES OF TRYING TO MOUNT EVERYTHING. ALL YOU HAVE TO DO
IS PLUMB THE LINES, WIRE THE THERMOSTATS, AND HEAT PUMP, THEN FILL THE SYSTEM.
THE NON PRESSURIZED TANK KEEPS AIR OUT OF YOUR SYSTEMS SO YOU DON’T HAVE TO.
Pressure Relief Valve
Manual Relief Valve
115V Hydronic Side w/ 3/4” or 1” Ball Valve
Thermostat Wire Entrance
Control Box w/ transformer
and Printed Circuit Board
230V Pump Ground Source HP
AVAILABLE SIZES:
HSS
®
-12, HSS
®
-20, HSS
®
-30, HSS
®
-40, HSS
®
-60, HSS
®
-80
2” inlet & 3/4”or 1” Ball Valve outlets
Water temperature not to exceed 150 degree max. Designed for 6 to 10 gallons
per ton of buffer volume. (Tank is not designed to be a hot/chilled water storage
device) 115V Pump on Hydronic Heat Side & 230V Pump W/ Water Side.
Hydronic Pump Relay standard Sensor for One Stage Heat, Two Stage Heat or
Heating & Cooling built in.