Bang & Olufsen DVB-S - User Guide - Manual (Page 15)

Bring up the satellite Setup menu >Access Control >Pincode
Setup.
Enable the pincode, and enter the TV Programs or Radio
Programs menu to select the channels that should be ‘locked’
(for further information, see page 11).
Bring up the satellite Setup menu >Access Control >Pincode
Setup.
Enable the pincode.
Then select the Country and the Maturity Rating you wish to use
(for further information, see page 11).
a) Check the signal strength and quality in the satellite Setup
menu >Installation >LNB/Aerial Setup. Choose the LNB and
Satellite and test the signal by pressing the green button.
If the strength and quality is too poor, check you LNB installation
or contact your installer.
b) Check that your smart card is still valid and updated.
> Press MENU to bring up the main TV menu.
> Press to highlight DTV (or SAT depending on your television
type), then press MENU to reveal the Sat software menu and
press GO to enter this menu.
> Select ‘Use previous software version Yes’ and press GO.
The satellite module will now restart and use the previous
software version. When a new version becomes available, it will
be offered to you.
Depending on your TV model, you may fi nd the software menu
like this instead:
> Press DTV to watch satellite TV.
> Press MENU to bring up the main DTV menu.
> Press to highlight OPTIONS, then press MENU to reveal the
software menu and press GO to enter this menu.
> Press to switch between ‘Yes’ and ‘No’. Select ‘Yes’ and
press GO.
You want to restrict the access to
certain channels, (Access
Control)…
You wish to apply Maturity Rating
to your satellite programs…
There is no signal, the picture is
poor, or several programs are
missing…
You have downloaded new
software for the satellite module
and it is no longer working…
If… Then…
15