Brother DCP-110C - Manual (Page 59)

5 - 1 TROUBLESHOOTING AND ROUTINE MAINTENANCE
5
Troubleshooting
Error messages
As with any sophisticated office product, errors may occur. If this
happens, your DCP identifies the problem and displays an error
message. The most common error messages are shown below.
You can correct most problems by yourself. If you need additional
help, the Brother Solutions Center offers latest FAQs and
troubleshooting tips.
Visit us at http://solutions.brother.com.
Troubleshooting and routine
maintenance
ERROR MESSAGES
ERROR
MESSAGE CAUSE ACTION
Cover is Open The scanner cover is not closed completely. Lift the scanner cover and then
close it again.
Data
Remaining Print data remains in the DCP’s memory. Re-start printing from your
computer.
Print data remains in the DCP’s memory. The
USB cable was unplugged while the
computer was sending the data to the DCP. Press Stop/Exit. The DCP will
cancel the job and eject the page
that is being printed.
High
Temperature The print head is too warm. Allow the DCP to cool down.
Ink Empty One or more of the ink cartridges is empty.
The DCP will stop all print operations. Replace the ink cartridges.
(See Replacing the ink cartridges on
page 5-20.)
Low
Temperature The print head is too cold. Allow the DCP to warm up.
Media Error The media card is either corrupted,
improperly formatted, or there is a problem
with the media card. Re-insert the card firmly into the slot
to make sure it is in the correct
position. If the error remains, check
the media drive by inserting another
media card that you know is
working.