Bang & Olufsen BeoSound 1 - User Guide - Manual (Page 11)

The BeoSound 1 has a built-in 24 hour
clock. You must set the clock yourself.
If you want to make use of the
Wake-up Timer function described on
the next page, you must first make sure
that the built-in clock in the BeoSound 1
has been set correctly. If BeoSound 1
has been disconnected from the mains
for approximately 30 minutes, the clock
must be set again.
Set the built-in clock
You must set the built-in clock manually while
BeoSound 1 is in standby.
While BeoSound 1 is in standby,
press and simultaneously
and hold until the time is shown
in the display. Both the digits
and the dot are blinking
If no time is set, the display will
show lines instead of digits
Press or to find the correct
time. Holding down or
will accelerate the change in
numbers
Press STORE to store the correct
time. The time is briefly shown
in the display
Set the right time
See the stored time
The stored time can be shown briefly in the
display.
Press both and shorty. The
time is shown briefly in the
display, the dot is blinking
While BeoSound 1 is in standby,
press the STANDBY button to
see the time in the display
NOTE! Pressing the red button on the Beo4 remote
control will show the time in the display
11
20.00
--,--
14.25
STORE
15.00
14.25
STANDBY
14.25