Baumfolder BAUM18: Pile Folder 1st Station (from 1999 thru 2005) - Manual (Page 31)

PAGE 31 TP10313-1
Check that the adjustment screws (26-4) are in contact with
the support rail (26-5) on both sides.
The basic position is marked by a notch (26-6) in the
fold-plate frame.
Setting Stationary Deflector
(Separate sheet deflector) (Figure 27-1)
The stationary sheet deflectors are installed and clamped
in place in the same way as the fold plates.
NOTE:
The fold plates in an 8-page folder will work in the #4 fold
plate position when four plates are desired. This applies to
folders equipped with three fold plates and one stationery
deflector.
Figure 26
STACKER (DELIVERY)
The motorized hang-on stacker has the following unique
features.
• Independent speed adjustment by using the speed
selector (Figure 28-1).
• Telescoping delivery tray that is fixed in position using
thumbscrews (28-2) below the tray.
• Nosebar with brush (28-3) that prevents sheets from
becoming trapped and eliminating a pinch point.
• The stacker can be mounted level or at an angle to assist
stacking of sheets that tend to spring open.
The stacker electrical power source is provided by
inserting the male receptacle on the stacker power cord into
the mating connector found on the left hand side on the
main electrical enclosure of the pile feeder.
Figure 27
Figure 28