Baumfolder BAUM20: Pile Folder 1st Station (early 2006) User Manual
Page 12
Advertising
TP10243-4
PAGE 12
The Easy-Mode is used for folds that require half of the sheet length or less going into the
foldplate. These folding applications normally operate with a 1.0 Inch sheet gap. If you are folding
half of the sheet length or more into the foldplate you must have a greater gap.
TURN THE EASY-PARAMETER ON/OFF
1.
Press the Machine Setup button
found in the top row.
2.
.
.
.
.
.
Press the
Sheet Gap
+ or - Buttons until P20 appears in the sheet gap display.
3.
Press the
Batch Count + Button
until
P25
appears in the sheet gap
display. You will now see the word “EASY” in the counter display
Batch Count + Button
until
P25
appears in the sheet gap display. You will now see the word “EASY”
in the counter display, see Figure E1.
Figure E1
Advertising