Baumfolder BAUM20: Pile Folder 1st Station (from 2002 thru 2004) - Manual (Page 18)

TP10243-2 PAGE 18
To get out of the Machine Parameter Settings Mode, Press again. The displays will
return to normal operations.
BATCH COUNTING SETUP
To enter Batch Count Set-Up, Press
1. This will bring up 3 display functions on the Control Panel.
First is the Small 3 digit display – this display must show
If the display shows any other Mode, the Batch Counter
will not function. To change, Press the or Buttons directly
UNDER the 3 digit display to change this Mode of Operation.
NOTE: If the display shows or the wrong batching device is
selected. These batching devices are Options not sold as standard equipment.
2.
In the Large 8 digit display you will see 2 display functions.
1. Is the number of sheets in the batch.
2. Is the time delay between batches.
A. In the first 3 digits of the 8 digit display, this is the number of Sheets in each batch.
To adjust the number, press the or Button directly UNDER
the display until the desired number is displayed.
B. In the last 2 digits of the 8 digit display, is the time between batches
setting. This setting moves in Tenth (10 th ) of Seconds, to adjust, Press
ood
ooo
oo
o
1 2