Operator controls, Installing fold plates & stacker delivery – Baumfolder BAUM20: Pile Folder 1st Station (from 1999 thru 2001) User Manual

Page 11

Advertising
background image

PAGE 11 TP10243-1

OPERATOR CONTROLS

The main operator control panel (Figure 8) is located at

the pile feeder. See the "Control Panel" section for a detailed

description of all the buttons.

1.0 Setting Folding Speed

The speed of the fold rollers may be set while the folder

is running! This is done by adjusting the speed control

potentiometer located on the top left side of the main control

panel. Clockwise rotation speeds the folder up; counter-

clockwise rotation slows the folder down.

1.1 Setting Stacker Belt Speed

An infinite speed range between high and low is set by

turning the control knob (Figure 9-1).

1.2 Emergency Stop Button

When an emergency stop button (8-1 & 9-2) is pressed,

the result is:

Sheet feed - stop

Folder drive - stop

Pile lift - stop

The pressure/vacuum pump continues to operate. The

emergency stop button must be pulled to release before the

machine can be restarted. An error message "StoP" will

appear on the readout.

The emergency stop buttons are found at the main

operator control panel (8-1) and the delivery control (9-2).

Figure 9

Figure 7

Figure 8

INSTALLING FOLD PLATES & STACKER

DELIVERY

Install the fold plates into the folder. When installing

the fold plates, take note of the symbol on the fold plate stop

(Figure 7-1). The swing deflector may only be brought

forward when the deflector symbol is also in the forward

position. Lock the fold plates in position with the clamp

levers (7-2). See "Fold Pan" section for fold plate setting

procedure.

Attach the delivery stacker (3-2) by hooking the hanger

brackets onto the round rods at the exit end of the folder.

Plug the stacker power cable into the corresponding outlet

on the main control enclosure on the pile feeder (Figure 6-

1).

Pull the handwheel (Figure 1-11) to manually turn the

fold rollers to be sure that they are operating smoothly.

Check for any foreign material, and be sure that the deflec-

tors do not touch the fold rollers.

+

h

0

+

+

+

1

2

3

4

5

6

7

8

9

10

1

BAUMFOLDER
CORPORATION

Advertising