Baumfolder BAUM20: Ifold Operation Manual - Manual (Page 3)

Start up procedures
The I-Fold software should start-up automatically when the
machine is turned on. If for any reason it does not start up properly
cycle power to the machine. If the I-Fold software still will not start up
contact your local dealer for support.
Shut down procedures
It is very important to shut down the I-Fold properly before
turning off the machine. Before powering down the machine press the
button to start the power down procedure. A pop up box will
appear asking if you are sure you want to power down. Press OK.
From this point the power down is automatic. Once the screen reads it
is OK to turn off your computer you can shut down the machine.
Cleaning Touch Screen computer
It is very important to shut down the I-Fold computer before
cleaning the computer screen. Use a CRT screen cleaner ONLY on the
interface touch screen.
Warranty Note
WARNING – Damage to the computer screen will occur if
any instrument other than the operator’s finger is used to navigate
the I-Fold screens. NOTE: Warranty on the computer will be void
if this is found to be the case for the computer failure.
TP10509 Page 1 of 29