Baumfolder D3 Drill (up to mid 2003) - Manual (Page 5)

5 TP10429
ELECTRICAL SYSTEM
Check the serial number tag on the top of the head casting (next
to tensioner) for voltage/phase/hertz and amperage required.
This tag also lists the time delay fuse amperage and the wire
size for the supply conductor.
STARTING
Two electric motors provide the power for this machine; one is
for the hydraulic power system and the other is for the spindle.
The electric motor for the hydraulic system drives a hydraulic
pump
that creates the force to push the drill heads down. The
spindle motor drives the drill head spindles through a set of
belts and pulleys.
The two motors are started by pushing the start button.
Both motors are turned off by a red mushroom stop pushbutton
located on the left side of the panel. This is a safety feature that
stops the entire machine.
WARNING
This machine is equipped with a safety interlock system which
prevents the spindle motor from being started when the hinged
top cover is opened, and automatically turns the spindle motor
off if the cover is opened after the spindle motor is turned on.
This safety feature is provided to prevent accidental contact
with moving parts. This feature must not be altered or tam-
pered with.
OPERATION
A) Open the hinged top cover.
B) Insert the drill bits into the drill head spindles.
C) Make sure that the retainer on the spindle is down over the
horseshoe lock washer.
D) The left edge of the drill head needs to be lined up with the
scale behind the drill heads.
E) To move the drill heads, first loosen the belt tensioner by
loosening the handle on top. Second, loosen the handle on the
drill head to be moved, then slide the drill head to the desired
location and tighten the handle. Then, using the racket on the
belt tensioner, rotate the belt tensioner counter clockwise until
the belt is tight. Then tighten the handle on top.
Caution: Make sure the belt is seated on each
pulley while tightening
F) If bits seem to stall when drilling, the belt may need to be
tighter.
G) For adjusting the depth of the drill bits, rotate the brass knurled
knob on the drill head. The proper drill bit depth is a slight
indentation into the wood block.
H) For drilling one or two holes you must remove the bits
from the other heads.
You cannot remove drill heads.
I) The table on the D3 drill is moveable. The template
supplied with the drill has three locking positions; center, max.
left, and max. right.
J) To move the table, push down the handle on the left side of
the table, once you start moving the table, release the handle
and it will fall into the next position in the template.