Baumfolder ND5 Drill (from 2000 thru 2002) User Manual
Page 11
11 TP10354
TROUBLESHOOTING
PROBLEM POSSIBLE SOLUTIONS
1) Drill heads
a) Check motor rotation of
wont come down
drive shaft with arrow on
belt guard. Switch two wires
of the incoming electrical cable to
correct rotation.
b) Relief valve may need adjusting.
Contact the BM Dealer or
Baumfolder office where you
purchased your ND-5 drill for
assistance.
2) Spindles stall
a) Dull drills, sharpen or replace
b) Check for low voltage
c) Check for belt drive tightness
d) Check for plugged drill bits
3) Drill head wont
a) Check for broken lift springs.
come back up
Contact the BND Dealer or
Baumfolder office where you
purchased your ND-5 drill for
assistance.
b) Oil guide shafts and pry up head
4) Insufficient
a) Check oil level
hydraulic pressure
b) Check voltage
c) Check relief valve. Contact the
BND Dealer or Baumfolder office
where you purchased the ND-5 drill
for assistance.
5) Frequent drill
a) Dull drills; sharpen. Or
bit breakage
replace
b)Use drill extensions
c) Cutting too deep in wood
blocks, reset properly
d) Excessive wobble of bits,
replace spindles
e) Drill less stock height (covered
stock)
f) Clean out drill bits after end of
each use.