Baumfolder ND5 Drill (from 2000 thru 2002) - Manual (Page 7)

7 TP10354
M) Use the impression in the wood block to set the corner
guide. Use the back gage bar clamps to adjust the guide
knob shown in Figure 1 to make slight adjustments to the left
or right.
IMPORTANT NOTES
1. For best results and to avoid knife breakage, no more than
1/2 inch of paper should be cut at any one time.
2. Turn the machine off when making adjustments.
3. Replace any guards that were removed before you use the
machine.
FIGURE 1 ROUND CORNER AND SLOTTING GUIDE
ROUND CORNERING GUIDE
MOUNTING BLOCK
BACK GAGE BAR
BACK GAGE BLOCK
WOOD BLOCKS
TABLE TOP
ROUND CORNER &
SLOTTING GUIDE
ADJ. KNOB