Baumfolder 714XLT: Air-Operations Manual (from 2006) - Manual (Page 12)

TP10289-3 PAGE 12
Before tightening the blade to the collar, slide the
blade with the collar loosely attached on the end of the
shaft. Then tighten securely, thus aligning both the blade
and collar, allowing free horizontal movement along the
shaft.
Place the blade, mounted on the collar, on the upper
shaft in the proper position where the cut is to be made.
Then move the blade and collar on the lower shaft so that
the two flat edges of the blades are pressed snugly together.
Too much space between the blades will produce a ragged
cut.
Space the rubber pull-out tires to support the sheet.
9.0 MAINTENANCE
9.1 Maintenance and Care of your
714XLT
The 714XLT Air Feed has been designed to give
you years of useful service, provided you maintain it
according to these instructions.
9.2 Lubrication
Apply one or two drops of light machine oil at all
slitter shaft bearings and the feed table bearings and idler
gear once a week. Be sure to keep oil off any surface
which may contact the paper.
9.3 Cleaning of Fold Rolls
Periodically wipe off the rubber surface of the fold
rolls using an approved solvent such as Surewash or its
equivalent. Surewash is available from BAUMFOLDER
in 1-quart (P/N 24108-001) and 1-gallon (P/N 24108-002)
containers. A complementary bottle of Surewash is
included with your machine.
9.4 Cleaning Filters
The filters on the pump should be checked periodi-
cally and cleaned as needed. The filters can be reached by
unscrewing the filter jars.
9.5 Photo Eyes
Occasionally wipe off the photo eye with a dry cloth.
9.6 Cleaning The Fold Stop Guides
The fold stop guides (See figure 4.7-1) should be
cleaned once a week with a dry cloth to keep the plate
moving properly.
9.7 Replacement Parts
To order replacement parts for your 714XLT Air
Feed, contact BAUMFOLDER Parts Department toll free,
800-543-6107.
Always be sure to give the model number and serial
number of your 714XLT to ensure receiving the proper
parts.